Rex Instruments HAWK MEASUREMENT Hawk Measurement ORCA Bed Level System

| Cancel

ProComSol develops HART communicators for mobile device software that bridges the gap between HART Protocol devices, allowing for configuration, monitoring, calibrating, and troubleshooting of HART instruments in industrial plants.

home > Brands> Hawk Measurement ORCA Bed Level System

Hawk Measurement ORCA Bed Level System

Product Description

ORCA Bed Level System
The ORCA Sonar Bed Level System will measure up to two density interfaces simultaneously. Typically these are bed levels / RAS blanket and floc / fluff layers. The sonar produces a high power concentrated beam, and provides critical plant control to optimize performance.

Primary Areas of Application:

Sewage Plant
Tank or Vessel
Mining
Water and Wastewater

Industries:

Concentrate Thickeners
Tailings Thickeners
Hi-Rate Thickeners
Paste Thickeners
Deep Cone Thickeners
Water and Wastewater Treatment

Principle of Operation
The ORCA Sonar Bed Level transducer emits a high-powered acoustic pulse, which is reflected from the interface density selected. The reflected signal is processed using specially developed software algorithms, that eliminate lighter floating densities and stratified layers, allowing measurement of RAS or BED levels. It can be calibrated to measure lighter densities like FLOC or one of the outputs could be used for a CLARITY output, similar to a basic turbidity transmitter measuring solids in suspension. By choosing the correct sonar transducer frequency, the ORCA sonar guarantees the optimized performance when measuring both light and heavy-density interfaces.

Dual independent analogue outputs to track two different interfaces, or clarity simultaneously, with the one sonar sensor
Easy calibration to track specific density interfaces, eg: floc / fluff layer - 1g/l, Bed 10g/l+
Industrial scum cleaning mechanisms, that do not require maintenance
No wiper blade assemblies

Accuracy: +/- 0.25%
Maximum Range: 24m (82ft)
Remote Electronics: -40°C to 70°C (-40¼F to 158¼F)
Sonar Transducer FRP Fibreglass: -40°C to 80°C. (-40¼F to 176¼F)
Electronic Actuator: 0°C to 80°C (0¼F to 176¼F) (recommend cover / heating for sub zero environments)
Operating Temp: -40°C to 70°C (-40°F to 158°F)